Thermoform kit for a hollow hanging flower ornament
Ready-to-print thermoform kit for a hollow flower ornament: heat a thin plastic sheet, press it between the female and male molds, and it forms a glossy flower-shaped shell. Each shell closes onto a printed base plate, and the two halves join into one hollow hanging ornament — no customization needed, just slice, print and form. The formed flower measures about 10.5 × 10 cm (design 105.5 × 100.9 mm), with a hanging hole for a ribbon or cord.
Complete kit: the ZIP carries the mold pair, base plates and closures, ready to slice and print
Two closure styles: Connector (screw caps + clips; this flower uses TWO threads, so two caps and clips hold the pair shut, and the hanging hole is cut through for a ribbon or cord) and EdgeRim (glued edge rim with an extra rim that holds everything with a single thread, one cap), each in its own folder
Material split: the molds are preferably printed in PETG so they don't stick to the PLA base when it gets hot during forming (PLA fuses to PLA; PETG doesn't); base plates, rim, caps and clips print in regular PLA
Plating options: each set includes a Full plate (everything at once) and Left/Right plates (one half each), plus separate Molds and Connectors files (the EdgeRim set also has a separate Rim file)
Customizable version available: this printable is the ready-made counterpart of the Thermoform Generator model
FlowerTwoThreads-Full (base plates, PLA): 40 min, 9.49 g
FlowerTwoThreads-Molds (PETG): 3 h 32 min, 115.4 g
FlowerTwoThreads-Connectors (caps + clips, PLA): 12 min, 1.89 g
Materials:
Molds: PETG (preferred — PLA molds fuse to the PLA base when it gets hot during forming; PETG doesn't stick)
Base plates, rim and connectors: PLA
Layer Heights:
Molds: 0.24mm (faster)
Base plates and rim: 0.20mm Standard
Connectors (caps + clips): 0.16mm High Quality (clean threads)
Print Time & Filament (Connector set):
FlowerTwoThreads-Full (base plates, PLA): 40 min, 9.49 g
FlowerTwoThreads-Molds (PETG): 3 h 32 min, 115.4 g
FlowerTwoThreads-Connectors (caps + clips, PLA): 12 min, 1.89 g
Tags: thermoforming, mold, flower-ornament, hanging-decoration, ready-to-print, petg, multi-part