Ready-to-print 3-photo winter frame, no AMS needed
Ready-to-print winter version of the Hanging Photo Holder, in the wide 3-photo size. Three photos hang from a thread on little pegs inside a two-color textured frame, with white snowflakes spilling over one corner and three little Christmas trees standing on the base.
No customization: print the parts and assemble as shown in the video.
Two-part frame: bottom and top each print on their own plate in their own color, joined by small pins, so no AMS is needed.
Three trees, one plate of bases: the small, medium and large trees share a single base plate.
DXF cut files: both frame footprints are included if you want to cut a backing in another material.
Layer heights: everything prints at 0.16mm except the trees, which print at 0.28mm — that is the layer height their zig zag is modelled for.
Frame, red top: 2h49m, 57.5g
Frame, white bottom with the pins and wire ends: 2h07m, 42.6g
Snowflake design: 50m, 11.7g
Small tree: 22m, 2.3g
Medium tree: 43m, 4.3g
Large tree: 1h22m, 8.2g
All three tree bases, one plate: 18m, 5.5g
Recommended Settings:
Nozzle: 0.4mm
Material: PLA
Layer Height: 0.16mm (frame, snowflake design and tree bases)
Layer Height: 0.28mm (the three little trees — intentional, it matches the layer their zig zag is modelled for)
Wall Loops: 2
Infill: 15%
Supports: Not required
Plates and Colors: The frame prints in two parts, bottom (with the pins and wire ends) and top, each on its own plate in its own color and joined by small pins, so no AMS is needed. The snowflake design prints separately, and the three trees share one plate of bases.
Tags: photo-frame, christmas, snowflake, ready-to-print, two-color, no-ams, home-decor, dxf-included