Snap-fit photo ornament, no glue, customizable size
A two-piece Christmas ornament that holds a photo, with or without an acrylic disc. The front clicks over the back on a snap ring, so no glue is needed, and the size is customizable to your own insert.
Snap-fit back: the front clicks over the back and holds the insert in place; a finger hole through the back pushes the photo out when you want to change it.
Customizable size: built around the chosen Design, so a round photo gives a round ornament and a square photo a square one. Tested with 8 cm round acrylics.
Insert depth: set Inner Height to what you are dropping in — with a 2 mm acrylic I use 2.8 mm, and 0.6 mm for the photo on its own.
Seven Designs: plain, scallop, wavy, wavy square, zigzag, garland wreath and bow (the last two in round and square).
Two colour methods: Designs with artwork print their colours into the face in their own filament (FaceDown), or as separate flat pieces to glue on (Multipart).
Cutting guide included: every export adds a flat 0.8 mm Guide piece shaped like the opening, 0.5 mm smaller all round, to lay on the photo and cut around.
0.16mm High Quality profile
Tags: christmas, ornament, photo-frame, snap-fit, no-glue, customizable, two-piece, multicolor